 |
 
-
Infeed dial
for depth control
-
Ball bearing
blade motor with fixed shaft (cannot gouge tires)
-
Ball bearing
supported mandrel for static balancing
-
Automatic
blade sharpener with manual override and blade guard
-
Minimum set
up time; fast one man operation
-
Console
master control panel
-
Console
master control panel
-
Work light
with flexible shaft
-
Large wheel
weight storage trays
|
The 1200-R comes crated, completely assembled,
wired and ready for immediate use. The cutter and drive motors are
60 Hz., 110-115 volt, single phase. Shipping weight is 500 lbs.
See Adapters and Accessories for more information
about the options for this model. |
- Complete Vibration control can be achieved
through truing and balancing
- Achieve faster and more consistent lap
times
- Tires will hug the track better
- Easy to operate
- Smoother runs because of reduced vibration
- Adapter plates to fit most race car,
legend car, and race truck lug nut patterns
- Reduces wear-and-tear on front-end parts
-
Automatic Cross Feed
-
Air Jack Ramp
-
Cones for Hub Mounting
-
Adapter Plates
-
Cones for Hub Mounting
|
The newest addition to the Amermac
line of products is the Model 1200-R Racing Truer with an optional
automatic cross-feed.
The truer is specifically designed for
racing tires and produces a flat surface or may be adjusted for an
angled cut of up to (plus/minus) three degrees. The Model 1200-R
comes with one adapter plate to your specification.
 |
